djiuser_UAPzMrwJbYVy
lvl.4
Flight distance : 3072448 ft
United States
Offline
|
I created a hyper lapse in waypoint and saved the coordinates for my hyper lapse to do future hyper lapses from the same area. Today I attempted to redo the same hyper lapse in reverse order. I went to the hyper lapse which I nicknamed “Home”. I clicked on the tab and proceeded to run in reverse order. I hit go. My Zoom proceeded to go somewhat in the area of the last coordinate and then it increased in altitude of somewhere around 382ft (my last coordinates wasn’t that high ) until I got the message altitude limit reached . The go symbol was spinning as if it was processing and beginning to take its journey but nothing happened . I waited awhile but it never got to correct coordinates or began to take pictures . I then set it to go in order, repeating previous steps, the same thing occurred where it goes close to proximity of the beginning but reaches maximum altitude (which is no where close in altitude where I started) and just hovers and does nothing. What am I doing wrong ? |
|