Hi,

We have a drone with the onboard system N3, linked with Futaba T14SG.
Whenever we try to save setting on assistant 2, those are applied, But then, if only you disconnect drone from the batteries all the setting comes back to factory settings.


How on earth do I save the setting?
We have had the same drone in the past and there was no problem with new settings configuration.

Hi there DronaVista, sorry to read the troubles you had. We already coordinated this with the related department that is handling these products and they have sent you an email that you just need to reply to, if possible kindly provide also some images of the version of the software that you are using along with a short video of the issue. We appreciate your patience. Thank you.