Has anyone tried to install this strobe on a Mavic Air
https://www.amazon.com/gp/product/B072NXX76P/ref=ox_sc_saved_title_6?smid=AJK4DS6MU5BUR&psc=1

The best i’ve found so far is the 4 LED Firehouse Strobe.

Hi, thanks for sharing this accessory. For a friendly reminder, please be cautious on using third-party accessories as this may affect the performance of your drone. Thank you for continued support.

That looks too big. I use these.

Bob Brown Posted at 2-19 17:25
That looks too big. I use these.

same here Bob, got a red one and white, the thing I like about them is that you can easily attached them to the drone and take them off  the drone.

Ceetron here as well, double sided tape and a elastic band to secure. (stays in place when folded/transported)

Bob Brown Posted at 2-19 17:25
That looks too big. I use these.

I agree with Bob Brown. Looks massive, and instead I also use the Cree Light. I waited for an ebay 15% off code and bought a pack of three from a trusted seller. Very happy with my purchase since it was cheaper than Amazon and they work great.

JJB* Posted at 2-20 02:53
Ceetron here as well, double sided tape and a elastic band to secure. (stays in place when folded/transported)

I used the scotch 3M fasteners... they work great and I can take them on and off.

Bob Brown Posted at 2-21 04:15
I used the scotch 3M fasteners... they work great and I can take them on and off.

[view_image]

Thanks, not sure if that for sale in The Netherlands.

Here’s my configuration
In addition to adding finger protection from the prop, the mounting bracket, which snaps on/off has a flat surface to which you can attach the strobes. This pic shows the attachment upside down. Also, you can remove the protector grates, and use the bracket as a holder for the strobes.

Note that red and white are side by side, instead of front and back, because the flat areas are on the sides.