We have an M600 pro used relentlessly to fly LIDAR.

Recently we had an error where the DJI go app reports an IMU failure. Switching to backup IMU.

I believe this is due to us shipping the m600 on commercial airliners and the way it is handled in transit. Possibly damaging the A3

I thought the solution would be to buy a new A3 and replace the existing.

However I've replaced the A3 and cannot get the DJI go app to recognise the m600 as such when Connected.

After installing new A3, When I turn on the m600 and open the DJI go app it shows only A3.

What am I missing or what should I be doing to install a New A3 and set it up on the m600 pro correctly?

Is the A3 ( roughly $1300 ) the correct part? Or should I have brought the A3 pro kit and replaced everything? (Roughly $2,300)

Thanks in advance

Just want to add some more visibility to this. Trying to fix it today

M600pro flyer lidar Posted at 6-3 13:45
Just want to add some more visibility to this. Trying to fix it today

Connect to DJI assistant 2 and then change default settings to M600 Pro?

Unfortunately, the firmware of your new A3 needs to be flashed. There are no tools available to the public that I can recall that can do this.

You will need to send it into DJI in order to properly have the A3 firmware flashed.