Hello all.

sorry if the same question was asked here - I was not able to find it...

Please, help me to solve the following problem:

If I switch the Tx (Futaba T14SG transmitter with R7008sb receiver) OFF, everything is working fine - the controller switches to the F/S, LED flashes blue color, the drone goes to the attitude that was set in the A2 Assistant, flies to the starting point and land. As far everything os OK.

But...

If I  turn the TX ON again there is no reaction from the cotroller. The blue LED is flashing and the drone continues to perform the F/S program... The Tx commands are totaly ignored by the controller. After auto-landing in F/S mode I have to disconnect battery to get control of the drone again.

What should I do to take control over the drone back after Tx switch ON during the F/S?

Thank you for for your answers.

JirkaM

Hello all.

sorry if the same question was asked here - I was not able to find it...

Please, help me to solve the following problem:

If I switch the Tx (Futaba T14SG transmitter with R7008sb receiver) OFF, everything is working fine - the controller switches to the F/S, LED flashes blue color, the drone goes to the attitude that was set in the A2 Assistant, flies to the starting point and land. As far everything os OK.

But...

If I  turn the TX ON again there is no reaction from the cotroller. The blue LED is flashing and the drone continues to perform the F/S program... The Tx commands are totaly ignored by the controller. After auto-landing in F/S mode I have to disconnect battery to get control of the drone again.

What should I do to take control over the drone back after Tx switch ON during the F/S?

Thank you for for your answers.

JirkaM