MoralDK
lvl.2
Flight distance : 186880 ft
United States
Offline
|
I just went to install a new gimbal yaw motor and gimbal ESC board. After getting the parts I thought I received the wrong board because it was too short and the mount holes were wrong. I found out that my P4A actually has a P4 arm/ribbon and ESC board. Did the P4A ever come this way? My P4A is a replacement from DJI and has since been back a couple of times for repair. I've always had a sketchy gimbal, so I'm wondering what's up. With the longer P4 gimbal, I must be loosing some ground clearance. I have to use a flat launch pad to avoid startup gimbal interference. Can I get some DJI input on this?
Since installing these parts and attempting startup - it doesn't. It gives a wimper of a startup beep and continues with an error beep and flash. I'll have to go in and check for connection issues. Where can I get error beep/flash info?
|
|