Is the below still relevant for the SC from DJi-Paul in the Ronin S forums-

"for the roll axis, as long as it not tilting one or the other when you let go, it should be fine"

"the motor will handle the rest' - with a mention of checking power usage

Cannot get the roll axis to balance without blowing out the tilt angle (tried riser and balanced lots of past gimblas- a tricky one on the Wee bill as well)

A73 and 16-35 F4

Thanks for any advice.

Have you gotten it to work yet?

Have you gotten it to work yet?

Hey everyone, I’ve been trying to balance my a7iii with a ride pro mic on my Ronin S but it keeps hitting the roll motor when I tilt the camera up. I don’t know how to properly balance it if I can’t make adjustments when it’s caught in between there. Any advice?

Shervin Koushan Posted at 7-24 05:42
Have you gotten it to work yet?

Not how I would have liked but like the post I have the roll axis centred and leave the motors to do the rest.
Concern I have is I can hear the motors working even without moving the gimbal. So again not sure if that’s ok

Carsalespro Posted at 7-26 03:31
Not how I would have liked but like the post I have the roll axis centred and leave the motors to do the rest.
Concern I have is I can hear the motors working even without moving the gimbal. So again not sure if that’s ok

Thanks for your answer. Have you tested it with other lenses?

Shervin Koushan Posted at 7-26 05:24
Thanks for your answer. Have you tested it with other lenses?

No, just the 16-35 f4