When using your phone connected wirelessly and changing mode ie fpv, tilt locked etc there is no indication on the Mimo phone display about the changed mode.

This almost defeats having the point of having the change mode buttons on the extension rod if you can't see what you have changed it too  ( without subsequently swinging the rod around to try and work out what it's current mode )

So dji if you could consider an update change to the rod / Mimo app to display gimbal change mode using buttons C1, C2.     Thank you.

Hello and good day MKosmo. Thank you for reaching out and for this request. I will forward this thread/request to the designated DJI department for further attention. Thank you.

The gimbal mode is shown, and updated, on the interface if you tap the relevant virtual button.  What's needed is for that to pop up automatically for 5 seconds when you change modes using the rod.

fansfe82067d Posted at 11-9 19:12
The gimbal mode is shown, and updated, on the interface if you tap the relevant virtual button.  What's needed is for that to pop up automatically for 5 seconds when you change modes using the rod.

yes I agree, if the updated mode was shown for 5s that would do the trick.