Please select Into the mobile phone version | Continue to access the computer ver.
DJI E800, DJI N3 and LB2 setup Drone shakes
833 0 2019-11-14
Uploading and Loding Picture ...(0/1)
o(^-^)o
hardrone
Second Officer

India
Offline

Hello,

I have an E800 setup mounted on my 650 frame. I have used 10000mAh LIPO and it worked fine.

Then I increased the capacity to 6S 22000mAh. I tried flying with 22000mAh battery but the Drone shakes much like arms have loosened up. But that is not true, in fact. The arms are perfectly tight. Also, while it shakes, it yaws too. There is something wrong in terms of power consumption in motor 1 and motor 3. So, it alternately yaws a bit.

I went back to my 10000mAh Lipo 6S pack just to check if there is anything shaking with this one. I just identified that the Drone did not shake this time. But it still yaws a bit alternately on Motor 1 and Motor 3 side.
Has this happened with someone before? Please let me know the probable reason behind this. Is there an issue with the 22000 pack? OR there is something wrong with the motor.

I have flown my Drone with 10000mAh battery hanging in the bottom and keeping on the top. It has worked fine in both the manner. It is since 22000mAh battery that I used on the top and it started shaking and irregular yawing in flight. After that, I have tried flying with my old 10000mAh battery on the top and bottom again, but no good result. The issue remained the same.

Please help. Thanks.

NOTE -
1) Weight of the Craft with 10000mAh - 2.3 Kg
2) Weight of the craft with 22000mAh - 4.2 Kg
3) Every time, any change in the position of N3, offset parameters have always been updated rightly.

2019-11-14
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules