Please select Into the mobile phone version | Continue to access the computer ver.
Ronin-S out of control ! Help!
9039 6 2019-11-21
Uploading and Loding Picture ...(0/1)
o(^-^)o
Baltachac
lvl.1

Argentina
Offline

Hi guys, thank you in advance for your time & help !
i have the following problem: I am from argentina, here we don't have technical support, I send a Ronin S to repair the trigger in chile, and it came back with a tilt drift issue,
after investigating i found this guy who teach how to solve a pan drift issue (https://www.youtube.com/watch?v=hpP1vo3IKrc) when i was in the app, in motor parameters, on the offset calibration of the joint angle, i misunderstood the tutorial and could not calibrate correctly with the joystick, and now i cannot repeat the calibration because it went crazy and hits the camera and force the motors, there goes a video of my case: https://www.youtube.com/watch?v=YyreIsG5hvo
i tried to ''restore gimbal setup'' but it didn`t work, is there any other way to factory reset? or to motor kill the gimball in order to reajust from the app without putting the camera in danger?
thank you really much ! hope it's possible.
2019-11-21
Use props
azifoto
lvl.1

Morocco
Offline

Hi,

It's amazing how I did the same thing, and it's being mouths that my ronin-s just sits aside,
Hopefully someone from dji will help us out.

good-luck.
2019-11-23
Use props
Baltachac
lvl.1

Argentina
Offline

Nooo, well good to know I am no alone in the sorrow !
Dji please help !
2019-11-24
Use props
Renina
New

Indonesia
Offline

After you turn on the gimbal, push the power button twice, that will deactivate the gimbal motor.
You can see the mode light on the ronin blinking when you do that.Do the same thing to reactivate the gimbal after you finished setting it.
2019-11-29
Use props
azifoto
lvl.1

Morocco
Offline

Thank you Renina for your suggestion , but it's does not work.
2019-12-18
Use props
azifoto
lvl.1

Morocco
Offline

Hi, did you find a solution?
2019-12-18
Use props
Baltachac
lvl.1

Argentina
Offline

azifoto Posted at 2019-12-18 08:27
Hi, did you find a solution?

hi !
yes ! actually thanks to renina, after deactivating the motors, i re did the joint angle calibration.
then power it off an on again and it was ok
also, re calibrate the joystick
https://www.youtube.com/watch?v=lixxauXADro
good luck everyone
2020-8-10
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules