Please select Into the mobile phone version | Continue to access the computer ver.
Camera gimbal re-calibration is not being stored
63 0 11-24 11:14
Uploading and Loding Picture ...(0/1)
o(^-^)o
Lalaser
lvl.1

United States
Offline

Phantom 3 Standard. Camera detetached from roll axis of gimbal after crash, and then epoxied back in place.

The camera is functional but the camera gimbal has a 45 degree tilt to one side. Likely due to me dot being able to epoxy the camera bracket back in the exact same position on the roll motor before the crash

Gimbal calibration works and the roll is calibrated out, and then the gimbal functions normally.

But the calibration doesn't get stored. The 45 degree tilt comes back with each power-on cycle
11-24 11:14
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules