Probably not needed but was just wondering is someone came across a set of prop holder that will still allow the MM to fit into the case.

I use simple, thin velcro straps about 2 inches long each. I wrap one around the top props and then one around the bottom props. Not entirely a professional look, but it works and fits the case.

JodyB Posted at 12-11 09:40
I use simple, thin velcro straps about 2 inches long each. I wrap one around the top props and then one around the bottom props. Not entirely a professional look, but it works and fits the case.

Good suggestion. Thanks, guess worse case a couple rubber band will work too.

Wiz33 Posted at 12-11 09:59
Good suggestion. Thanks, guess worse case a couple rubber band will work too.

Yes, I saw a post the other day where someone was using rubber bands.

The pgytech solutions won’t fit the case

Hi. Thank you for reaching out to DJI Forum. I hope that our valued DJI member can provide you the best response and information for this inquiry. Thank you for your valued support.

You can snip off two fingers from a rubber glove and use them as propeller holders.

That looks like a good idea.

Tervist Posted at 12-11 14:07
You can snip off two fingers from a rubber glove and use them as propeller holders.

[view_image]

Well that's one way to do it.