Hello everyone,
I'm new to this forum...
My problem:   When I fly my M2P, I take off and the RTH is recorded by the aircraft, and that's fine !  When I land somewhere else and switch off the engines, then I take off again, the drone record the new RTH and when I press the RTH button on the RC the drone don't come to me where it first took off, but returnes to the place I landed it !  How can I make the drone NOT to record the first landing point and return to it's first take off point, where I am ? ? ?


Thanks for your replies and advises.

Zanouli

Have you tried turning on dynamic home point?

Hello Captain,

Well, I tried... but it woul'nt work because I did not used the correct divice ... it don't have GPS... I'll try with my phone with a GPS tomorrow...

Thanks for the advise.

I have an other question regarding the batteries: can I us one batterie on two drones M2P ???? As I read that the batterie software is updated when the drone updates it's software. Is it to pair the drone with the batterie ???

Best regards.

Zanouli