Hey guys
I just brought back my Ronin 1 to get some usage on it.

Connected it via USB to the computer, started up DJI Assistant (v. 2.5) and saw the following:
GCU (Loader 1.0) Firmware (1.4)
IMU (Loader 0.8) Firmware (3.1)
Battery (Loader 0.0) Firmware (0.0)
Remote STart/Stop (Loader -.-.-.-) Firmware (-.-.-.-)

For IMU und Remote Start/Stop is an update available.
After updating the IMU and restarting the gimbal, the same firmware number stays and still (Update available)

The GCU says NO UPDATE but on click there's still an update ready to be download, but it's stuck and doesnt finish.

If the Gimbal is running and connected via USB, after about 10min it looses the balance.

Did anyone else had these issues and know a fix or what to do next?

Hey guys
I just brought back my Ronin 1 to get some usage on it.

Connected it via USB to the computer, started up DJI Assistant (v. 2.5) and saw the following:
GCU (Loader 1.0) Firmware (1.4)
IMU (Loader 0.8) Firmware (3.1)
Battery (Loader 0.0) Firmware (0.0)
Remote STart/Stop (Loader -.-.-.-) Firmware (-.-.-.-)

For IMU und Remote Start/Stop is an update available.
After updating the IMU and restarting the gimbal, the same firmware number stays and still (Update available)

The GCU says NO UPDATE but on click there's still an update ready to be download, but it's stuck and doesnt finish.

If the Gimbal is running and connected via USB, after about 10min it looses the balance.

Did anyone else had these issues and know a fix or what to do next?