Hey,
I have a problem with my joystick controller on my ronin S.
Whitout touching the joystick, the CH1 and CH3 behave as I'am using it. As you can see on this screenshot of my DJI assistant while I'am absolutely not touching the joystick controller...
Any Ideas? Is that possible to calibrate the joystick controller?
Hi Victor, sorry for the difficulties with the Ronin-S, please refer to the screenshot below to perform the Joystick Calibration to see if the issue persists.
Thanks you . it's better CH3 works, but unfortunately the CH1 is still not fixed. CH1 still say that I put pressure on it (last calibration I did CH1: -100 ).
I did the joystick calibration 10 times..
Any ideas?
DJI Mindy Posted at 2-11 19:14
Hi Victor, sorry for the difficulties with the Ronin-S, please refer to the screenshot below to perform the Joystick Calibration to see if the issue persists.[view_image]
Thanks you . it's better CH3 works, but unfortunately the CH1 is still not fixed. CH1 still say that I put pressure on it (last calibration I did CH1: -100 ).
I did the joystick calibration 10 times..
Any more ideas ?
victorNZ Posted at 2-13 07:50
Thanks you . it's better CH3 works, but unfortunately the CH1 is still not fixed. CH1 still say that I put pressure on it (last calibration I did CH1: -100 ).
I did the joystick calibration 10 times..
Any more ideas ?
If the issue persists after successful Joystick Calibration, it is recommended to send in the device for the diagnosis, please start a ticket here https://repair.dji.com/repair/index?site=brandsite&from=nav and send in at your most convenience.