I've been flying the Inspire 2 / X7 combo since release. It's been nothing short of fantastic. Recently, however, I have been struggling with severe jello during video. Increasing shutter speed makes it more apparent, while dropping shutter speeds just creates a blurry image. I have replaced the three rubber isolation bits that connect the gimbal to the aircraft - to no effect. Very frustrated as this expensive setup has been rendered essentially useless as of late. Here is an example of the issue: https://vimeo.com/397327793/1a31f042cc

I have the same problem - mainly on a 50mm lens. sometimes individual buildings become blurry, a strange blur is created on them. maybe a week ago the drone came from a repair shop. the problem is now. DJI Inspire 2 -X7

Did you check the camera flying in front of you?
Does it shake?

If so, did you check the arms are still thight? On some the glued joint arm/motor have come loose in the past.
Is there anything loose?
Did you try with new props
Are the soonhoods thight
Are ND filters tuned thight

Did the camera have a hit or got bend lately
Did you try playing around with the gimbal settings?