Anybody else have an issue with the M300 Enterprise Smart Controller not keeping time? I saw that the original smart controller had the issue where it went back to January 18, 2018. I have the same issue where it loses the time as soon as it's switched off and sometimes goes back to January 18, 2013. This caused me issues using PIX4D as it didn't like the old dates on the photos. Any comments welcomed.

Hi!
You might be better off posting your question in the 'products' section of this forum.
That is way more active.

I've found out that the issue is when I have an SD Card in the controller. I can re-format it and it will work for one or two power cycles, then the issue comes back if I leave the card in. Tried various brands and sizes of SD cards and the problem persists.