Hi Everyone,

I'm a little bit lost with all this new accessories for the phantom 2.

I've got de Phantom 2 of last year. I try to configure my New 2.4GHz Remote Control (left dial, built-in Lipo battery) whick look awsome.

My problem, it's apparently my channel mapping who is callibrate correctly on lightbridge software. Left is Left, Right id right. But when I try it on my phantom assistant, Left equal right and right equal right. It's the same when I calibrate the remote in the phantom assistant.

I've unpluged the original receiver to connect the dbus of my lightbridge air system at the place as I saw in a video. Is the problem could come from there?

Thanks for your help. I read a lots of topic, but I can not find a solution.

Best Regards,

Loïc

Just rev these channels...If my memory is correct you can do this in the p2 assistant in NAZA mode.

Blade_Strike Posted at 2014-11-30 08:15
Just rev these channels...If my memory is correct you can do this in the p2 assistant in NAZA mode.

Better use the remote control assistant software to calibrate your remote control.
http://www.dji.com/product/dt7-dr16-rc-system/download

Perfect thanks for the information Julain

Thanks a lot for this information. I will try the RC assistant ;-)