Hi,

I am looking for a new transmitter and receiver for my F450 with Naza-M v1.
Would the DJI DJ6 RC Transmitter and 2 Antenna Receiver Part 31 -UPGRADE KIT- P330 be compatible ?

Regards,
Ole-Andre

That works, make sure the 2.4GHz RC transmitter works with the 2.4GHz receiver, the same as the 5.8GHz

DJI-Cathy Posted at 2014-12-3 03:32
That works, make sure the 2.4GHz RC transmitter works with the 2.4GHz receiver, the same as the 5.8G ...

Great, thanks!
Seams like a lot simpler setup than my current DX8 :-)

DJI-Cathy Posted at 2014-12-3 03:32
That works, make sure the 2.4GHz RC transmitter works with the 2.4GHz receiver, the same as the 5.8G ...

I replaced the receiver in a V1.2 with a part 31 and I my DJ6 can bind with the new receiver but then the Phantom LED blinks yellow fast and in the Naza assistant I cannot see the  DJ6 Transmitter.  If I put the old single antenna receiver back in it will bind and work with an SR6 Transmitter, but if I r&r the receiver it does not perform the same.  As I say above, I can bind and the light stays off in the battery compartment, but no reaction when I try to start the motors.  And in the Naza M assistant there is no stick or switch action.  I am in D-Bus and have tried everything I can think of

Could you please send your email to support@dji.com?
You may ask Cathy for help, thanks a lot!