Hi All,

The attached link is the file that the previous firmware flew at the correct AGL and now with the new update the M300 executed the flight 10m under what it's supposed to.

We are doing a terrain-following operation with a 3rd party flight planner for Lidar Missions. The exported AGL is in AMSL and there should be no difference to where you are taking off. Could it be that DJI updated the ellipsoidal height or is it just a setting in the RC?

DJI_Pilot_2.KMZ
https://drive.google.com/file/d/1qidM0B4-KZa7niMANPNI60cc0YfIdEeZ/view?usp=share_link


Thank you.  

DJI will not provide you with any solution regarding a third-party application.  

By the way, what is this app?  
Are you sure that's not the problem?  
Have you confirmed the problem using exclusively DJI Pilot 2?
The KMZ you provided doesn't show much.  It would be better to share your raster.

LV_Forestry Posted at 3-29 08:08
DJI will not provide you with any solution regarding a third-party application.  

By the way, what is this app?  

The issue is ONLY with Pilot 2 v06.01.01.00

We also test litchi and UgCS and DJI is the only one that has this particular issue.

The software we are using is the Phoenix LiDAR FlightPLanner.

AlexMenko Posted at 3-29 09:36
The issue is ONLY with Pilot 2 v06.01.01.00

We also test litchi and UgCS and DJI is the only one that has this particular issue.

Does Litchi provide RTK ?

I just tried with Pilot2, actually it's not good at all.
I also use UGCS for this kind of functionality and there everything is fine. I will investigate more deeply later.