I have read somewhere about the torque setting for the 2 screws that hold the quick release prop hubs to the motors. I can't find it now. Does anyone know the torque setting values or where that info can be found please.

DJI highly recommends using a torque wrench to install the mounting plates and set the screw torque between 0.5 Nm to 0.8 Nm.  [ .4 to .6ft lb]  [4.4 to 7.0 in lb]

sthuemmel Posted at 2015-8-23 23:32
DJI highly recommends using a torque wrench to install the mounting plates and set the screw torque  ...

Many thanks sthuemmel.

sthuemmel Posted at 2015-8-23 17:32
DJI highly recommends using a torque wrench to install the mounting plates and set the screw torque  ...

where is this written?