RossDoug
lvl.1
United States
Offline
|
Hi,
I haven't been able to bind my new O3 air unit and would appreciate any help and suggestions.
My process was:
1) Activate O3 air unit
2) Upgrade O3 air unit to firmware V01.02.0000
3) Upgrade goggles v2 to firmware V01.06.0000
4) Switch goggles to O3 air unit mode
5) Power cycle goggles
6) Power on O3 air unit
7) Press bind button on goggles (it starts beeping)
8) Press bind button on O3 air unit (the red light starts flashing)
They don't connect, so I eventually turn off the air unit to avoid overheating. I have tried downgrading the O3 air unit to firmware V01.01.0000 to no avail. I have also tried with various firmware versions installed on the goggles. I read some people had success by downgrading the goggles, switching to avata mode, and then upgrading the firmware again before switching back to O3 air unit mode, so I have tried this too.
One extra piece of info that I find strange: While a connection is never established, when the devices are both in bind mode, the goggles stop beeping as soon as I turn off the O3 air unit. This seems to indicate some level of 'seeing each other' but an inability to complete the handshake. I'm at a loss here so any suggestions are more than welcome
|
|