Hello,


I was wondering if there is a separate way to update the high bright monitor, LIDAR, Handles, etc other than with the 4D firmware update through the DJI Assistant 2 app? Meaning, are there separate firmware packages for them?

Thank you,


Todd

I never seen anything and as far as I’m aware, they just say to have everything attached when doing the update, and I am by no means in expert or anything but I would say if you didn’t get to update any of the equipment with the main update, you should maybe revert back to manufacture or an older firmware And then attach everything again and redo the update. I know this doesn’t answer your question like at all but just in case you had any issues just thought I’d throw my two cents. Hope this helps a little bit.