I have the new gimbal wheel TX NDJ6 and Lightbridge. Before, I used LB with a Futaba T14SG but wasn't happy because tilting the H3 3D wasn't smooth enough. So I wanted to use the new tlting wheel on the TX. I connected the NDJ6 with the short red plug and black plug cable to the LB. Red plug into NDJ6 and black into LB. No Signal. Phantom goes to failsafe. Solution: Just put the black plug into TX and red into LB and it works.

That is correct the red to the LB and the black to the Tx.  I have it set up on my P2Z3 with LB.

Tahoe_Ed Posted at 2014-12-11 02:59
That is correct the red to the LB and the black to the Tx.  I have it set up on my P2Z3 with LB.

I also had the same problem because I relied on Phantom2 mounting video and it's not the right way. The red connector on the LB. Thank you for the post.