Please select Into the mobile phone version | Continue to access the computer ver.
Ronin-m died after upgrade to latest firmware
1047 2 2015-9-9
Uploading and Loding Picture ...(0/1)
o(^-^)o
stworkshop
lvl.1
Singapore
Offline

Can someone please help ?

After i upgrade from original firmware to latest Ronin-M Assistant Software v1.9 & GCU firmware v1.1...


my ronin-m becomes unresponsive even though the power is on.


When i open the Ronin-M Assistant Software and go to the "upgrade page",  my GCU firmware goes back to v5.1 and tells me to upgrade to latest version 1.1. And when i try to upgrade again following all the instructions, power cycle the device... i come back to the same status v5.1.... i have done this many... many times.


And i always see 2 error message at the bottom of the upgrade page for a few seconds...
1. "Not DJI intelligent battery" in green
2. "IMU must be upgraded" in red


I was suppose to use it for a job tomorrow !!! I should not have upgraded. How can i go back to original firmware ?
2015-9-9
Use props
DJI-Cathy
Second Officer

Hong Kong
Offline

Send your email to support@dji.com, I will help you
2015-9-10
Use props
nafetsone
lvl.3
Flight distance : 770472 ft
  • >>>
Belgium
Offline

again somebody, dji fix this! I need the ronin next week don't want to send it for repair just for a firmware probem
2015-9-10
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules