Hi! So, here's my problem. I just got the DJI Mic 2 and the camera adaptor. Updated all the firmware including the adaptor. When connecting the RX tot the adaptor I get the right confirmation message of good connection. Then, when I put the adaptor in the MI shoe on my A7iv the camera says it's connected but the audio recorded by the TX is not getting through. (don't see the audio indicators on the camera picking up anything)

When I put pressure on the RX, pushing it a bit down on the camera the connection is made correctly and the audio is getting through the adaptor to the camera. So, it can work.. When I release the pressure the audio recording stops but it stays connected.

RX > newest firmware
TX > newest firmware
Adaptor > newest firmware

The MI shoe looks fine on the eye, as does the adapter connections... but could it be the MI shoe? if so, any fixes repair options?

Any help, solutions on what I can do about this? Thanks in advance.

Hi! So, here's my problem. I just got the DJI Mic 2 and the camera adaptor. Updated all the firmware including the adaptor. When connecting the RX tot the adaptor I get the right confirmation message of good connection. Then, when I put the adaptor in the MI shoe on my A7iv the camera says it's connected but the audio recorded by the TX is not getting through. (don't see the audio indicators on the camera picking up anything)

When I put pressure on the RX, pushing it a bit down on the camera the connection is made correctly and the audio is getting through the adaptor to the camera. So, it can work.. When I release the pressure the audio recording stops but it stays connected.

RX > newest firmware
TX > newest firmware
Adaptor > newest firmware

The MI shoe looks fine on the eye, as does the adapter connections... but could it be the MI shoe? if so, any fixes repair options?

Any help, solutions on what I can do about this? Thanks in advance.