Is there a way to go back to a firmware update on the Remote control for phantom 2 ( the old version DJ6 - not the new NDJ6 remote control).
I have update today to the 1.0.1.24 and i practically lost the zenmuse h3d3 control. It goes only up and down. Not in between, furthermore, i loose connection with the Phantom after few minutes. I am getting red light on the receiver. After switching the remote control for few minutes connection is restored. Is there a reset button to go back to the previous firmware something ?

Same here.  I just updated my firmware from RC assistant and my gimbal control is doing so erratic tilting and cannot go in the middle tilt.

Have you tried to calibrate the RC?

Autumn Posted at 2014-12-17 07:38
Have you tried to calibrate the RC?

I have this problem too, I have recalibrate in RC and P2 software, as well as manually.

I have no gimbal X1 control.

I NEED THE OLD FIRMWARE.