RC and Inspire Disconnect

burington · 2015-10-24

After upgrading to the new DJI Go 2.4 and turning on my RC and Inspire, there is no connection. I tried to link the RC with the Inspire using the app but it doesn't do anything. The RC has a steady blue light like it is a slave controller. I only have one controller and there is no option on the app to select Slave or Master. How do I get these connnected again. If anyone knows the answer to this I would really appreciate some help. Thanks.

Machoman · 2015-10-25

Blue light is bricked - you need reset bin. Slave has rosa light.

RichJ53 · 2015-10-25

burington

I saw your post, and I have not had this happen... but you can try relinking you controller to the Inspire as the master. Look in the manual for the linking procedure and the tiny button on the right front of the Inspire.

It may have just lost the radio bind after the firmware update.

Rich

burington · 2015-10-25

RichJ53 Posted at 2015-10-26 02:36
burington

I saw your post, and I have not had this happen... but you can try relinking you controll ...

Rich I have tried this too. The problem is that the Go app acts like it is only for a Standard. The app no longer gives me a choice for Master or Slave. I just can't get there from here. The Link RC does nothing.

sheepheadfilms · 2015-11-13

RichJ53 Posted at 2015-10-25 11:36
burington

I saw your post, and I have not had this happen... but you can try relinking you controll ...

What tiny button? I looked all over my Inspire and didn't see a tiny button.

Tharg (from the · 2015-11-14

sheepheadfilms Posted at 2015-11-14 06:15
What tiny button? I looked all over my Inspire and didn't see a tiny button.

The tiny button that is shown in the user manual on page 33
Obviously you have read the user manual yes?......

RichJ53 · 2015-11-14

sheepheadfilms Posted at 2015-11-13 22:15
What tiny button? I looked all over my Inspire and didn't see a tiny button.

Look in the manual page 33 and look at the diagram showing the location of the button in the front of the Inspire1. Follow this procedure for relinking the craft.

Rich

sheepheadfilms · 2015-11-16

RichJ53 Posted at 2015-11-14 08:25
Look in the manual page 33 and look at the diagram showing the location of the button in the front ...

I found it thanks!