New firmware out for the Inspire 1--makes the X3 Inspire Camera compatible with the OSMO-- The X3 Inspire Camera must be updated in the Inspire not on the OSMO-- Jack

Can you provide a link? I am unable to location this firmware on the DJI site

Fred D Posted at 2015-12-8 01:04
Can you provide a link? I am unable to location this firmware on the DJI site

It's under DJI --Inspire One --Downloads

Jack

Fred D Posted at 2015-12-7 17:04
Can you provide a link? I am unable to location this firmware on the DJI site

You should be able to find it under Inspire1 downloads

Its working now did a quick video today!

https://youtu.be/lG5li_BYPwo

Hi , Jack, thanks for the information!  
1) The X3 gimbal on the Inspire 1 is now compatible with the Osmo. Note that you must attach X3 gimbal to the Inspire 1 before updating the firmware.
2) Do not attach X3 gimbal to the Osmo to update the firmware.
3) Calibrate the Inspire 1 X3 gimbal when using it on the Osmo for the first time.
4) Only use Inspire 1 aircraft to update the Inspire 1 X3 gimbal. Do not use this firmware to update the Osmo gimbal.

Westwoodfilms.c Posted at 2015-12-8 06:39
https://youtu.be/lG5li_BYPwo

Interesting... the gimbal mount for the camera is on the left right for the Inspire 1 X3 while the actual Osmo is on the right...

sdchew Posted at 2015-12-8 09:44
Interesting... the gimbal mount for the camera is on the left right for the Inspire 1 X3 while the ...

Yes, the gimbal roll direction is opposite.