eric
lvl.1
United States
Offline
|
I purchased a new RC with the gimbal control wheel on the upper left for my P2V+ (Ver. 2), hooked it all up and when the Vision software is on the software controls the gimbal up and down movements, but the wheel does nothing when the Vision software is turned on.
If the Vision software is off, the RC's gimbal control wheel will move the gimbal but it doesn't seem to lock in and wants to self-center to about 45 degrees on the vertical axis.
Can I get the RC's gimbal wheel to work when the Vision software is on? Otherwise it seems like a waste of time.
Thanks, Eric. |
|