Hi folks,

Just bought the Ronin M and have been doing all the calibration etc and had it all working perfectly.

I decided to update the firmware and the Gimbal went smoothly and still works but during the controller update, I received a 502 Bad Gateway error on the update panel.

Now the controller is dead (see light in image) and won't upgrade or work at all.

Any advice would be gratefully received...

Nick

Fixed!

I switched off the Ronin M and just left the controller plugged into the DJI Assistant software and the controller showed as having no firmware installed.

Ran update, installed ok and now working.

Will leave this here for anyone experiencing the same issue...

Nick