Hi,

I've been carrying out the Inspire 1 firmware v1.7.0.90 updates from 17-Mar-2016.


Now, on my DJI GO app (Android v. 2.7.1), the About section has the following:

Version 1.6.00.40 (doesn't seem up to date)
Camera 1.7.00.90 (looks up to date)
Remote Controller 1.5.80 (no idea)

Can anyone from DJI or otherwise please tell me if the above indicates I am fully up-to-date yet?

Thanks

you are good....The 1.7.00.90 was a camera update only:

New firmware updates are available for the Inspire 1 and Osmo, please visit the respective product pages to download and update your firmware.

The Inspire 1 firmware version number is updated to v1.7.0.90, and the Osmo firmware version number is updated to v1.5.2.0.

DJI GO app iOS version is updated to v2.7.1 and Android version is updated to v2.7.1.

For the Inspire 1:

Major Updates:

1. Added auto saving of gimbal roll-axis fine tuning settings. Settings now save on power off.
2. Fixed gimbal misalignment issue when powering on.
3. Added Digital Zoom Control when recording video at 720p, 1080p and 2.7K. Put two fingers on the screen and pinch to zoom out, open your fingers to zoom in (up to 200%).
4. Optimized D-Log and D-Cinelike color space.

Notes:

1. This firmware can be downgraded to v1.6.0.40 or later only.
2. Camera version v1.7.0.90 and aircraft version v1.6.0.40 should be displayed on DJI GO as this update is only for the gimbal and camera system. The version will only display correctly in DJI GO after connecting to the Internet when upgrade is complete.
3. Digital Zoom Control only supported by DJI GO app iOS and Android v2.7.1.

terrylewis Posted at 2016-4-4 12:24
you are good....The 1.7.00.90 was a camera update only:

New firmware updates are available for the  ...

Thanks very much Terry!

I've just installed the latest update (7 April 2016) and I'm now as follows:

DJI GO Android App 2.7.2
Version 1.8.01.00
Camera 1.8.01.00
Remote controller 1.6.0 (main controller, not Slave)

Pretty sure both of our two batteries have now been updated too, so all that remains is to check the Slave RC