Hi
I have just got my Inspire1 v2 RAW and I can seen there are some changes from my old Inspire 1 v1 rev A
Improvments are good BUT I have a large problem:

- Lose all GPS sattelites every time landing gears are in UP-position.

When gears are lovered all works fine, but as soon they are going up, heli get 0 satteltes and go in to P-ATTI mode.

Is this a cabeling issu? To short cables?
Is this a firmware issu? New encryption is messing with GPS?
Is this a RF interferance issue from new motors?
Is this a location issu and Inspire raw is not tested in Sweden?

Best regards
Janne Jansson

Sounds like you got a lemon, send it back.

If I got a lemon, I not just sending it back I'll be very-very unhappy.

I have issue with raw too losing gps it was caused by gimbal itself. If you remote gimbal do you have signal with legs up? Very confused by this but the x5r unit itself seems to be killing gps signal in my testing

Specifically I tested x5 on pro airframe no gps issue. X5r on new x5r pro airframe constant cutouts in gps, x5 on x5r pro airframe no issue., no gimbal no issue. Frustrating to have to ship back, I updated firmware as previous testing was on version that shipped. Going to do one more test which is x5r on pro airframe but worried about firmware as it only has x5 (i1pro) firmware. Waiting to hear back from support.

This seem to be a deal breaker for DJI. If they can not make there hi-end machine work, they lose all cred.

I think they can make it work (many are having good experiences), perhaps just an assembly issue for some units. In any case, do post if you find a solution and I will do the same.

Here is a part solution. This GPS problem only appear away from home (activation location) = GPS-software bugg.