Hello everyone!

I've recently purchased a DJI Ronin-M and also a thumb controller. I first updated all of the firmware to the latest version on the Ronin, Thumb controller and reciever. I then turned on the ronin and perssed the bind button on the reciever, i then pressed the on button on the thumb controller. It successfully binded as their was a green light on both the reciever and the thumb controller. However. When i use the thumb controller and press either up / down / left / right, nothing happens.

I've looked at the app and the internal reciever is on, i've reset the ronin a few times, reset the thumb controller and nothing seems to have fixed it. Each time, it binds successfuly but no movement when i use the controller.

Any ideas?

Thank you!

Hello!
Please review the Thumb Controller User Manual at http://dl.djicdn.com/downloads/r ... _Manual_en_v1.0.pdf
From P12-P15, it introduces the basic settings of thumb controller, please check the setting of the 3 axes.

In our official website, you can find the tutorial video about tuning the thumb controller, please have a look：http://www.dji.com/product/ronin-thumb-controller/info#video

For any problem, please contact us freely!

DJI-Adela Posted at 2016-5-6 00:03
Hello!
Please review the Thumb Controller User Manual at http://dl.djicdn.com/downloads/ronin_thumb_ ...

same exact issue