Since I updated to 2.8.2, I also realized, that Gimbal calibration hangs at 9% forever. Powered off craft and ended 2.8.2 at iPhone 6S (9.3.2 (13F69)).

Because I have a backup of 2.8.1, I removed 2.8.2 and installed 2.8.1 again. So far this helped out of the weak transmission signal problem (please see other thread in forum).

But restoring 2.8.1 did unfortunately not solve the Gimbal calibration problem. Now, also with 2.8.1 gimbal calibration dies at 9%. Please see attached image.

I really appreciate any help and/or workaround.

Cheers, Roland

Hello Pipobike, did your P4 experience any crash or damage? What's the firmware of your drone now?

DJI-Paladin Posted at 2016-5-29 06:37
Hello Pipobike, did your P4 experience any crash or damage? What's the firmware of your drone now?

App: Version 2.8.2
Aircraft: Version 01.01.0301
Remote Controller: Version 1.6.0
Do you also need the Flight Controller Serial Number? I do not really want to post it here public.

DJI-Paladin Posted at 2016-5-29 06:37
Hello Pipobike, did your P4 experience any crash or damage? What's the firmware of your drone now?

On my iPhone I still have 2.8.1.

After about 15 or 20 Power On/Off of the craft and restarting DJI GO App I could meanwhile calibrate gimbal again.

Pipobike Posted at 2016-5-30 16:50
App: Version 2.8.2
Aircraft: Version 01.01.0301
Remote Controller: Version 1.6.0

PS:

• Even beeing a newbie, I yet hat no damages and no crashes and I am still flying the first set props Lv20, about 14 hrs and 120 km flight ;)
• Form my point of view, you may treat this as "closed". ;)
  

Pipobike Posted at 2016-5-31 00:03
PS:

Even beeing a newbie, I yet hat no damages and no crashes and I am still flying the first  ...

So does this issue disappear when you attempt to calibrate the gimbal again?

I'm stuck at 50%, new P4pro, no crash, successfully calibrated IMU, Reinstalled DJI Go 4, still have the same issue. Any lights on resolving this? thanks