Dutch Falcon
New
Netherlands
Offline
|
Issue: Spinup of right front prop (seen from the center of the I1 looking forward) when shutting down the motors with CSC.
Landing the Inspire 1 , gently pulling the left control stick towards me, until iit is on the ground.
Then pulling both stickd towards me en towards each other.
Motors wind down except the right front motor.
That one spins up , lifiting the I1 some 50-60 degrees , and then spins down.
Happened twice so far and now I have to shut down the motors by pulling the left stick towards me and keekping it there unit the motors have stopped.
This behaviour showed up after a SW upgrade to version 1.8.
Is there anyone out there that also has come across this behaviour?
KInd regards,
Cees van der Leeuw |
|