Hello
Hope somebody can assist me
After i updated the firmware on my A2 controller off my s1000 the red led flashes cont. (nothing changes when remote connects/ disconnects with controller)
Ive checked and double check all my settings
From setting up everything from scrach on assistant software and trying different batteries.
Motors doesnt start
Compas calibration fail
Isod shows it pics up satellites
did anybody else experience this after the latest update?
Everything was fine before that
Is it possible to revert back to previous firmware?
Can it be because i dont use the lightbridge setup?
Could you happen to provide a small video of the LED sequence, as the spacing between the flashes can read differently. Could you clarify what firmware you were on before and what firmware you are on now?
New
DJI team