Can someone help

after updating all my ronin system

both remote and thumb control stop working

luis

Same here!

I had to send mine in, they replaced remote and thumb...the update is only for Ronin MX yet the early Ronin loads it anyway..get on the phone sooner than later..
hope its resolved soon! cheers
Darrin

Update has just killed my thumb and remote and I have a shoot in the morning.
I cannot understand how can you allow this to happen DJI?! {:4_154:}

How am I going to work tomorrow?

Same exact thing.  The upgrade to version 3.1 has been a disaster for me, for four reasons:

1. It completely killed my RC (I saw the warning not to upgrade the RC firmware too late.)
2. My thumb controller would not bind, as you describe.
3. The Ronin motors were jerky, not smooth.
4. My Ronin would frequently go into psycho robot rampage, spinning wildly.

So I re-installed version 3.0 and the Ronin seems to working better... maybe.  BUT... I now have a totally dead RC and a thumb controller that won't bind.

QUESTION FOR DJI:   How can I "downgrade" my thumb controller firmware and RC firmware so they work with Ronin firmware v3.0?   I need a way to control my Ronin.   Your latest firmware (from DJI_Focus_Installer_v2.4) killed all of my controllers.

PLEASE HELP!

Same thing has just happened to me. This is rediculous that DJI haven't drawn much greater attention and warnings to this such as on their home page. Can DJI please give me an email address and phone number for where I should returned the fried RC and Thmb controller to in the UK?

https://forum.dji.com/forum.php? ... mp;page=1#pid636946 ?