Hi,
I've problems to take of the S1000 with A2 controller + Lightbridge 2. The motors don't start when I make the start up process.
I use the A2 Assistant software 1.9 and everything seems good and up to date.
- A2 Controller firmware version : 2.7
- A2 IMU firmware version : 2.5
- A2 GPS module firmware version : 2.6
- A2 revceiver firmware version : 1.1
- A2 LED firmware version : 2.1
IMU, compas and stick calibrations seems good too. I have no error message from the A2 Assistant software.
Video return is good with DJI Go app and I can control the pitch with gimbal dial and record/shutter button works fine.
I just can't start motors, and I don't know what to do more..
The only strange thing is the LED of the A2 controller unit is always red !
Can someone help me ?
Thanks.

Have you ensured that the A,E,T,R commands are going in the right direction when you move the sticks? Have you done a RC calibration? The red LED on the A2 is fine when you're not using the built in DR16 receiver.

DJI-Jamie Posted at 2016-9-11 06:35
Have you ensured that the A,E,T,R commands are going in the right direction when you move the sticks ...

Yes, RC calibration has been done. So I will check tomorrow if the A,E,T,R commands are going in the right direction.. but I think it's good.

Aurél. Posted at 2016-9-11 23:01
Yes, RC calibration has been done. So I will check tomorrow if the A,E,T,R commands are going in t ...

Please keep me posted on the outcome.

DJI-Jamie Posted at 2016-9-12 01:37
Please keep me posted on the outcome.

I tried again today the A,E,T,R commands and unchecked the REV mode for E (CH2) and T (CH3) and motors start again !
Thanks you Jamie for your help.

Aurél. Posted at 2016-9-13 22:23
I tried again today the A,E,T,R commands and unchecked the REV mode for E (CH2) and T (CH3) and mo ...

Glad you're up and running. Thank you for the update.