Hey DJI.

I have had some issues with my Matrice 600.

First issue is using the new Zenmuse Z3 camera on it. all firmware are updatet on the matrice and the controller. When turning on the M600, the connection is lost for a few seconds, then re connects for a few seconds, and then Looses Again. It keeps going like that.
I have testet the Matrice without the camera, and had no problems, also tested it with the X3 camera, with no problem. Do i need a firmware upgrade for the Z3, or how do i solve the problem?

I have bought a set of TB48s batteries, and mountet it on the Matrice 600, and the app says it has a firmware problem, and need to be updatet. I havent been able to find out how to solve this. Cant take off with them or do anything other than replacing them with the TB47s and fly. How do i update the batteries so i can use them with my Matrice 600.

Hope to get help soon.

Thanks.

You may potentially need a firmware update. Do you happen to know what firmware is currently on the Z3? In regards to the batteries, you should be able to update via the Assistant 2 Software. Are you able to access the software to check for updates?

I updatet the firware on the batteries now with the assistent. Works

I dont know the firmware version on the Z3 - Any idea wich version i need for it to work? And how do i update it or downgrade if needed? - The Matrice Support site dosent contain any firmware for the Z3

i have same problem , my zenmuse z3 not work in matrice 600 , i waste my money ,
I'm disillusioned with DJI

DJI-Jamie Posted at 2016-9-16 06:35
You may potentially need a firmware update. Do you happen to know what firmware is currently on the  ...

i have same problem , my zenmuse z3 not work in matrice 600 , i waste my money ,
I'm disillusioned with DJI

it does not work! It works very bad to inspire 1 LAG problems in matrice 600 directly does not work.

Today tested M600  with Z3, RC's  wheel for camera tilt working much delaying,