I have flown my  Phamtom 3 approximately 31 times, I have not crashed it or even made a hard landing but now it keeps flashing Gambal motor overload. The camera will try to move up and down but will stop but it will move from side to side. Anyone with any ideas?

To clarify, that Phantom 3 model do you have? Did you notice this after a firmware update or long term storage? Have you checked the gimbal ribbon cables for any tears or snags?

It is a Phantom 3 Standard and it had only been two days since I had last flown it, and no tear in cables

Hello sir, please turn off aircraft, then unplug pin cable, plug it again. Restart it and check again whether you have the same error or not.