s.s.gibbs1.emai
lvl.2
United States
Offline
|
when i used my inspire with the dual controller set up i noticed i had to set a static channel instead of auto to get a video signal that did not drop out. the second controller dropped very often. the master seemed fine when set to channel 17 but in auto it never moved off of 10 which seemed to be pretty low a signal. i am ok with setting the master to 17 but there does not seem to be a way to set the slave, it is on 10. i am not sure if it is a bad controller or if there is some way to change the channel on the slave?
thanks.
|
|