Wobbly prop mounts. Two different P4P+ all motors the same to a degree..

I don't think it's a big deal, as the mounts are screwed in pretty firmly. But would be interesting to see what a DJI member has to say about it.
The only woobly thing i enountered on my P4Pro is on the Remote Controller, the clips that hold a Smartphone 1 of them is just very little looser than the other, but you don't even notice it if you aren't a perfectionst

Perhaps intentional to stop over tightened screws cracking plastic clips ?

That is not normal, I'm an engineer and no designer would make anything like that !!!!

Just checked mine, and the plastic bits are firmly held against the motor can.  No movement at all.  A bit like my Mavic order really....

Andy

If the screws holding the plastic part are shoulder screws the I can see the part being a little loose for alignment purpose. The shaft of the motor will hold the prop in alignment.

I just checked mine, the white plastic prop holders are very secure, no movement, I would not be flying if mine we're wobbling like that, send it back or tighten yourself with a bit of medium thread lock adhesive on the threads

Think that might call for a bit of DIY it's certainly doesn't look right , QC was off that day..

All tightened up.

Just a heads up for people to check over the craft before flying

Hello DJI , hello ,
will you reply to this thread ? is that normal , some kind of new damping solution for potential craft vibration issues?
DJI KEN MANDY PANDY ? hello