Hello - I have downloaded the Litchi App.  Flew two different missions.  In both cases, after a few minutes, I get a "Disconnected" message on the app.  It seems like I can still control the Phantom and when I use the remote to trigger RTH - that worked fine.  Last night when I tried, I was flying in my residential area - about 300 feet up and about 800 feet away when I got the message.  Anyone have any ideas?  I am using the P3 Standard.  Thanks!

From what I have seen, if you had the DJI Go App also running, this could cause the disconnect to appear.

Microcyb Posted at 2017-1-4 12:13
From what I have seen, if you had the DJI Go App also running, this could cause the disconnect to appear.

I thought of that as well.  Just to make sure I am not off base - to force close on iphone, you double tap the home button and then do the flick up to close...correct?  If so - that is what I did.

Hkdman Posted at 2017-1-4 12:20
I thought of that as well.  Just to make sure I am not off base - to force close on iphone, you double tap the home button and then do the flick up to close...correct?  If so - that is what I did.

That is correct

Trying don't use Litchi App too much. they still have bugs

WYHSniper1007 Posted at 2017-1-4 15:14
Trying don't use Litchi App too much. they still have bugs

Not true, it's a solid app. I even heard they wrote the code on the Go app for DJI.

WilliamM Posted at 2017-1-4 16:47
Not true, it's a solid app. I even heard they wrote the code on the Go app for DJI.

But, if you use litchi to control the drone and it fall down, nobody will take the responsibility for that. The flight data dji won't admit that

Have you used the DJI GO app and was that not satisfactory?

DJI Go, is okay, however Litchi APP has much and nicer features.

are you logged out? Try logging into Litchi.