After doing an update this afternoon, my gimbal won't tilt up and the camera won't focus. Anyone else experiencing this?
DJI Support anything that's known?

try a rollback of the firmware? if works, install newer one again...

For rollback, you need DJI Assistant 2

Nees Posted at 2017-1-4 13:25
try a rollback of the firmware? if works, install newer one again...

For rollback, you need DJI Assistant 2

Thank you. I'll give that a shot and report back.

Perhaps try calibration of the gimbal first... See if that makes it move. Does it initiate normally?

fans16b1ea7c Posted at 2017-1-4 14:08
Thank you. I'll give that a shot and report back.

Besides, please try to do the IMU calibration and gimbal calibration.
Please keep us posted.

DJI Mindy Posted at 2017-1-4 19:15
Besides, please try to do the IMU calibration and gimbal calibration.
Please keep us posted.

I have done numerous IMU calibrations, and done automgimbal calibration a few times as well. Also, performed a remote calibration. I now am seeing "wheel error, re center gimbal" ??

fans16b1ea7c Posted at 2017-1-4 20:36
I have done numerous IMU calibrations, and done automgimbal calibration a few times as well. Also, performed a remote calibration. I now am seeing "wheel error, re center gimbal" ??

I seemed to fix the error. I did a factory restore, restarted the Mavic, then did a firmware refresh to the current firmware. Gimbal error fixed.

fans16b1ea7c Posted at 2017-1-6 09:59
I seemed to fix the error. I did a factory restore, restarted the Mavic, then did a firmware refresh to the current firmware. Gimbal error fixed.

Glad to hear that you figure it out. :-)