I have a Mavic and run it with a Galaxy S7 and Go4 app.  At first the app crashed a couple of times and would drain the controller battery so I did a factory reset on my phone, turned on developer mode and USB debugging.  Since doing this I have had no problems with the app except when I first turn on the mavic and get ready to take off the auto takeoff button on the GO4 app is the landing button instead.  If I tap it the app says landing even though it is sitting on the ground and then the button changes to the takeoff button and works fine.  Is anybody else experiencing this or know how to fix it?

I would sync your flight records and delete/reinstall the GO app.

DJI-Ken Posted at 2017-1-22 15:07
I would sync your flight records and delete/reinstall the GO app.

Ken,
I will try this and let you know if it fixes it.  Thanks for your reply.

Jeremy

fanscc552007 Posted at 2017-1-23 15:10
Ken,
I will try this and let you know if it fixes it.  Thanks for your reply.

Sounds good.

DJI-Ken Posted at 2017-1-23 21:26
Sounds good.

I have the same issue with the auto takeoff showing landing instead, and tapping it results in it asking me if I want to land, even though the aircraft is still on the ground. This is on a brand new smart controller and Mavic 2 Pro both using the latest firmware. While I never used the auto takeoff feature with my Inspire1, I still expect it to do what it advertises.