michael
lvl.1
Flight distance : 641394 ft
United States
Offline
|
I got a new Phantom 2 with H3-3D gimbal, iOSD mini, and fpv. Got everything mounted and hooked up. I powered up to test the fpv, gimbal, and iOSD and all worked fine. Then I wanted to make sure all firmware was updated before first flight, as many have stated this was imperative to prevent potential fly-always. Firmware seemed to update properly. Then I power cycled and now the gimbal does nothing. The Phantom powers up fine, goes thru preflight routine and all seems good, except the gimbal does nothing. No fpv signal or anything. When I go to the update tab on the phantom software, the two gimbal items (gimbal imu, and the other one) aren't listed any more as they were before I updated the firmware.
Thinking the gimbal may have gone bad, I tested it with my old Phantom 1. I turned it on and the gimbal powered up and initialized just fine. Mounted it back on the P2 and nothing.
Has anyone had this problem before? I tried searching the forum but didn't find anything. Don't know what to do at this point and I'm getting really frustrated. Help!
|
|