Great weather today so tested the GSP again, but pria to that I thought I would use an old 3d plot that I had run a few days ago to save time.
I found the old 3d run and went to change a few of the points just to mix it up a bit and not have two runs looking the same for alalysis reasons,  I was greeted with
"could not edit finished mission" Question, is this my setup or has this software another hidden problem. If I am missing something please enlighten me, maybe I have to be connected to the craft???????


ricci

Had you tried making up another route just to see if it would take that one? Did you make any changes lately, like software updates etc.?

Hi Jamie,
I did make another 3d map and it was editable. I have not made any changes to any software since the last DJI firmware. I have never tested this action even in the beta so I can’t say if anything has changed.

ricci

I found it's only editable until the mission is flown, after the mission has completed it cannot be edited, or at least I have not found a way to do it?

SkySight Aerial Posted at 2017-3-11 01:34
I found it's only editable until the mission is flown, after the mission has completed it cannot be edited, or at least I have not found a way to do it?

Thank you skylight for confirming this, at least its not a software glitch that has just appeared.

ricci

If you slide the mission to the left you get the option of "copy" or "delete" the mission. The one you copy is editable.

nil Posted at 2017-3-11 06:49
If you slide the mission to the left you get the option of "copy" or "delete" the mission. The one you copy is editable.

Thanks nil, well spotted.

nil Posted at 2017-3-11 06:49
If you slide the mission to the left you get the option of "copy" or "delete" the mission. The one you copy is editable.

Hi Nil,
that a good way around the issue, thank you.

ricci

yes I agree this is an issue, I have reported it among others they are apparently working on for months now.

UAVServices Posted at 2017-3-15 14:06
yes I agree this is an issue, I have reported it among others they are apparently working on for months now.

Hi,
I was on the beta test of this software and I don’t remember the problem then but maybe I did not test it this throughly. I hope they can bring this up to spec as a usable tool, I use autopilot for most of the work that needs camera control and all the other assets GSP is lacking at present.

ricci

nil Posted at 2017-3-11 06:49
If you slide the mission to the left you get the option of "copy" or "delete" the mission. The one you copy is editable.

I had the same issue. Thanks for the solution.

I didn't have this problem until updating GSPro to the new release!