Hi guys,

Just a routine check for me haven't been flying the bird in a while so I start it up in my house and calibrate everything making sure everythings up to date and such..  

I get an Air Encoder Error it tells me to restart aircraft or contact DJI if persists.  I did that twice and its still there...  I have attached the screen capture.
UPDATE: 4th time I tried I rebooted the app, the controller aswell.  Now the message didn't come up.

For what its worth I wanted to address a potential bug/glitch.

Install the camera X4s or X5s and reboot. Should go away. Theres another ling about this http://forum.dji.com/thread-88962-1-1.html

Had this only 1 time but forgot to screen shot it!

I had the same think happen today I ignored it and just started again, turned off then restarted the new i2 firmware upgrade 15 min, with my laptop not the iPad, then updated the batteries, then I updated the 2 remotes. All went well and it has fixed a few bugs in the process.

Is this all right out of the box, or was it after a firmware update?