I updated the bird correctly .
Started the master RC  , in the beggining everything ok etc ... At the end of updating instead of Green light i got RED.
The file was showing not success. Started from the beginning but NOTHING now !!!!!!
Any ideas ? I tried different cards , different card readers but the RC is DEAD.......

txt shows:
==========1970.01.01 00:00:12==========Packet: /mnt/usb/WM610_FW_V01.02.00.17.bin,Result: ErrorFailed to obatin firmware version. Power cycle the remote controller to upgrade the firmware again.

I had the same error, then I did the remote upgrade via the gimbal and now everything works as before. Took me about 10min to get the remote upgraded.

If it does not work, try also to relinked, the quad with the remote as shown in the manual.

Good luck

I updated the craft first, this caused the controller to loose contact with the craft.
I then updated the controller using a USB stick. after this everything was back to normal. controller reconnected fine. Took a while tho.

After a long chat with dji they send a file which solve the problem , everything works now.....

alexmarnas Posted at 2015-2-28 17:47
I had the same error, then I did the remote upgrade via the gimbal and now everything works as befor ...

contact 24*7, they will help

alexmarnas Posted at 2015-2-28 17:47
I had the same error, then I did the remote upgrade via the gimbal and now everything works as befor ...

Remember to upgrade both ur aircraft and RC

AC went like a breeze. update via camera. took about 5 min.

Only thing I guess. It was updating my remote in 2 parts.

first green light, and seconds after it started updating again.

another green, and then it was updated.

make sure you do them seperately. remote On/ AC off and vice versa.

regards,